tone control circuit 2 transistors

a simple tone control circuit 2 transistors. Tone control is an electronic circuit that used to control bass, middle, treble, volume, and balance tones. Tone control circuit can you meet on audio device

Tone control function on the amplifier is you can set the size of the bass, middle, and treble tones

Usually tone control is installed before the amplifier circuit and controlled through the front panel using a potentiometer

A simple tone control circuit can be created by using 2 transistors

tone control function on the amplifier

if you make the amplifier without tone control then the resulting sound will be ugly and boring. The sound of bass, middle, and treble does not come out

tone control function on the amplifier is to bring up the sound bass, middle, and treble and my friend can set the size of the tone

Also read

If the power amplifier used is a stereo type then you can adjust the balance or balance of loud speakers left and right speakers

Tone control can be divided into several types as for the types of tone control are as follows

simple tone control circuit without transistor

the following simple tone control circuit is usually called the passive tone control. That is tone control without using the reinforcement process. Here’s the passive tone control scheme

tone control function on the amplifier

a simple tone control circuit 2 transistors

a simple tone control circuit 2 transistors or also called active tone control is a type of tone control that uses the reinforcement process

Tone control of this type has a better result than the tone control without the transistor like the picture above

a simple tone control circuit 2 transistors

As in previous articles about the difference between mono audio and stereo that you need to know is if the power amplifier pal is a stereo type then to produce stereo sound you also have to create a stereo type of tone control

stereo tone control can be made by assembling the above 2 pieces and making one of the stereo into channel L and the other into channel R and buddy can add a balance control on the output that serves to adjust the sound produced by Loud speaker L and R

Also read the how to install the correct potentiometer

Leave a Reply

Your email address will not be published. Required fields are marked *